Page
2
of
4
FXLD1012C4I LED FIXTURE
Version 0.1
OWNERS MANUAL
02/15/2012
www.lightronic.com
Lightronics
Inc.
509
Central
Drive
Virginia
Beach,
Va
234354
757
486
3588
installing a commonly available 1/4 Watt, 120 Ohm
resistor across the DATA - and DATA + wires at the
last device. If you have only a few fixtures very close
together and a very short run to the controller then you
may be able to operate without the terminator.
OPERATION
Operating options are set using the LCD display and 4
buttons
(MENU, UP, DOWN, ENTER)
on the rear of
the fixture.
Push
MENU
to access the operating options. Then use
UP
and
DOWN
to scroll through the available choices.
When you reach the option you want to set or change -
push
ENTER
.
Now you can view the current setting
for the option and/or change it. Push
ENTER
to save
your changes. See the "MENU NAVIGATION"
diagram for additional details.
There are 7 main operation modes: DMX, Color Fade,
Color Change, Color, Master Auto, and Master Sound,
and Master/Slave Operation
DMX OPERATION
Use the DMX512 menu to set the starting address of
the unit. You can set the starting address of the unit
with the
UP
and
DOWN
buttons.
The fixture uses eight channels assigned as follows:
CHANNEL 1: Master for the RGBW channels.
CHANNEL 2: Strobe rate for the RGBW channels.
CHANNEL 3: Red level (255 = maximum).
CHANNEL 4:
Green level (255 = maximum).
CHANNEL 5:
Blue level (255 = maximum).
CHANNEL 6:
White level (255 = maximum).
CHANNEL 7:
RGBW Color selection for 25 colors
and
effects.
CHANNEL 8:
Mixing speed for channel 7 functions.
DISPLAY ON/OFF
You can set the display so that it will turn off after a
short delay by using the
Display _OFF
menu. Push
MENU to turn it back on.
COLOR FADE
The Color Fade mode cycles smoothly through a
sequence of colors. Use the
COLOR FADE
menu to
set the speed and activate the option. The range is
from 00 to 255. 255 is fastest.
COLOR CHANGE
The Color Change mode switches through a sequence
of seven colors. Use the
Color Change
menu to set
the sequence speed and activate the option. The range
is from 00 to 255. 255 is fastest.
COLOR
The Color menu enables you to set the unit to one of
15 colors or OFF. Use the
Color
menu to select a
color. 00 is OFF.
MASTER AUTO
The Master Auto mode causes the unit to cycle through
both the Color Change and Color Fade sequences.
There is no selection or speed setting. The effect
begins when you enter the
Master Auto
menu.
MASTER SOUND
The Master Sound mode causes the unit to cycle
through the Color Change sequence in sync with music
bass notes. There is no selection or speed setting. The
effect begins when you enter the
Master Sound
menu.
FXLD1012C4I REAR PANEL VIEW
MENU
UP
DOWN ENTER
FUSE
DMX IN
DMX OUT
SELECT MENU < >
DMX512 ADDRESS 001
POWER
