The first step in installation, after making sure power to fixture is disconnected, is to
remove all existing components of the previous fixture, leaving only the body. Place
the GO
2 Retro
End Adaptors between the base of the fixture and the T-Bar. Secure the
GO
2 Retro
End Adaptors in place with the supplied tech screws (4).
Hang GO
2 Retro
Power Tray on tab and slot as shown above. Using the ballast
disconnect supplied (accepts up to 12 gauge wire), make power connections and
ground connection to body.
Lift GO
2 Retro
Power Tray into position. Slide GO
2 Retro
Power Tray into brackets
on End Adaptors.
Insert the GO
2 Retro
Louver pins into the louver slots of the GO
2 Retro
End Adaptors
and close.
Slide the telescoping end of the GO
2 Retro
Power Tray into place, resting on the End
Adaptors. Tighten the integrated white thumb screws of the GO
2 Retro
Power Tray
securing it in place.
The installation of our GO
2 Retro
is complete.
Installation of the G0
2 Retro
For more information regarding the GO2 Retro please consult specification sheet A10-32.
