4
Design Features
Installation
A.
RCA Input Jacks
– Line Level from Radio Pre-outs: The industry standard RCA jack
provides an easy connection for signal level input. They are platinum to resist the signal
degradation caused by corrosion.
B.
Gain Control:
The input gain control is preset to match the output of most source units.
They can be adjusted to match output levels from a variety of source units.
C.
Adjustable Crossover Frequency Control:
50-250Hz. Low Pass only on Models
X1.1000.1D & X1.2000.1D.
D.
Speaker Connections:
Follow correct polarity, and do not Ground any speaker wires. Do not
connect any speaker wires together.
E.
Crossover Filter Switch:
(Models X1.400.2 & X1.800.4 Only)
HPF for High Pass - Mid-Tweeter.
Flat for All Pass - Full Range.
LPF for Low Pass - Subs.
F.
Pass Thru Outputs:
The Pass-Thru provides a convenient source for daisy-chaining an
additional amplifier without running an extra set of RCA cables from the front of the vehicle
to the rear amplifier location.
G.
Power Fuse:
If this Fuse should blow, determine the cause or see your authorized dealer.
Never replace the fuse with one of greater value than the original
H.
Power Connector terminals:
Connects Power, Ground, and Remote
I.
Phase:
(Models X1.1000.1D & X1.2000.1D Only) Used to vary the inversion of the output,
0°-180°, from input source.
J.
SubSonic:
(Models X1.1000.1D & X1.2000.1D Only) A high pass filter designed to prevent
frequencies below the audio range from being applied to the subwoofer from the amplifier.
Improving subwoofer performance and power handling.
K.
Bass EQ:
(Model X1.1000.1D & X1.2000.1D Only) Variable 20-80Hz frequency control. Boost
controlled by remote.
L.
Remote Level/Bass EQ Control:
(Models X1.1000.1D & X1.2000.1D Only) Remote level
control attenuates Gain set on the amplifier by up to
-
20dB. Bass EQ control is 0 to +12dB
Boost of the frequency (20-80Hz) set on the amplifier.
M.
Master / Slave Switch:
(Model 2000.1D Only) Used to set the amplifier to master or slave
when strapping.
N.
SLV IN (slave):
(Model X1.2000.1D Only) When strapping, this is the slaved amplifer input
from the master amplifier.
O.
MAS OUT (master):
(Model X1.2000.1D Only) When strapping, this is the master amplifer
output to the slave amplifier.
INSTALLATION CONSIDERATIONS
The following is a list of tools needed for installation:
Volt/Ohm Meter
Wire strippers
Wire crimpers
Wire cutters
#2 Phillips screwdriver
Battery post wrench
Hand held drill w/assorted bits
1/8" diameter heatshrink tubing
Assorted connectors
Adequate Length—Power Wire
Adequate Length—Remote Turn-on Wire
Adequate Length—Grounding Wire
Summary of Contents for Storm X1.1000.1D
Page 62: ...62 Italiano...
Page 63: ...63...
