ENGLISH
Installation:
Be sure to check the unit for damage before use. Use the original packaging or a suitable
transport or storage packaging to protect the product from dust, moisture, etc. when not in use.
The device can be installed either upright or suspended. The device must always be fixed to a
fixed and non-combustible, approved carrier (e.g. traverse) or an appropriate surface. Note the
load limit of the selected installation position (e.g. for tripods). A minimum distance of 50 cm from
the walls must be maintained.
The opening of the bracket must be used to fasten the device. Always provide a second,
independent safety backup for the device, e.g. with a safety cable.
Work on the device (e.g. assembly) should always be carried out from a stable and permissible
platform. Make sure that the area below you is closed off.
This machine is designed for vertical fog output. Please make sure that the nozzle of the fog
output is always vertical and do not try to use it horizontally.
WARNING! (Risk of injury due to falling down)
Improper installation can cause considerable injury and damage!
The installation of the device should always be carried out by experienced personnel and
must be carried out in compliance with the mechanical and electrical safety regulations in
your country.
Hint! (Fog fluid)
Disconnect the device from the mains before filling!
Do not fill with hot liquids!
Only use high-quality water-based fog fluids recommended by your dealer. Other fog
fluids can lead to clogging or dripping of the device.
Suitable fog fluid:
lightmaXX Vertical Fog Special Fluid - LIG0015661-000
The fog fluids recommended by the manufacturer are environmentally harmless and can
be disposed of via the sewer.
Make sure that there is always a sufficient amount of fog fluid in the tank.
A too low tank level can lead to pump damage and overheating of the heating element
during operation!