ENGLISH
Cleaning:
The heating element should be cleaned regularly (every 30 operating hours) to avoid deposits.
In addition, regular cleaning of lines and nozzles is strongly recommended, e.g. with LightmaXX
cleaning fluid (LIG0010221-000/250 ml).
Please use only high quality cleaning fluids!
Procedure:
-
Empty the fog machine and pour the cleaner into the tank as delivered.
-
Operate the fog function of the machine a few times in a well ventilated place.
-
Adapt the number of required repetitions to the degree of soiling.
-
Remove the cleaner completely and rinse the tank properly with distilled water.
Maintenance:
-
IMPORTANT
: Always set the output to Zero and wait for minimum 30 seconds before to
switch off the unit.This allows the unit to execute its cleaning process so all the remaining
fluid is removed from the internal circuits.
-
Switch off the unit, unplug the mains cable and wait 10 minutes until the unit has been
cooled down.
During inspection the following points should be checked:
-
All screws used for installing the device and any of its parts should be tightly fastened and
may not be corroded.
-
Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free
from any deformation.
-
The mains cables must be in impeccable condition and should be replaced immediately when
even a small problem is detected.
Instructions for refilling of the fluid tank:
Fog fluid should be added when the machine shows"
FOG FLUID EMPTY
".
