Technical Specifications:
DMX channels: 2CH
Voltage: AC 230V - 50Hz
Fuse: 15 Amp
Power Consumption: 750W
Dimensions:
400 x 85 x 150 mm
Weight: 2,1 Kg
Operations:
There are 3 operating modes to choose from:
1, Manual 2, Sound Active 3, DMX
Manual Mode
To run the Strobe in Manual mode, set all dip switches to the “OFF” position.
In manual mode the unit will function as a normal strobe light, Rate (speed) and intensity
(brightness) are set directly on the unit. Note that these settings are made by using the controls
on the rear of the unit. Once the settings are made they can only be changed by physically
adjusting the controls on the unit. Be aware of this if you plan on installing your strobe in a
permanent installation.
Flash speed is controlled via the SPEED control
Flash dimming is controlled via the DIMMER control.
Sound active Mode
To run the Firecracker Strobe in Sound active mode, set dip switch 9 to the “ON” position. The
Dimming will still be controlled by the DIMMER control on the back of the unit. Note that these
settings are made using the controls on the rear of the unit. Once the settings are made they can
only be changed by physically adjusting the controls on the unit. Be aware of this if you plan on
installing your strobe in a permanent installation.
Flash Dimming is controlled via the DIMMER control.
Flash Speed is controlled by the Music
DMX Mode
To run the Strobe into DMX mode, set dip switch 10 to the “ON” position. You can now set the
required DMX address using dip switches 1 to 9. The start address for this fixture is 1. Please
refer to the chart below for DMX functions.
DMX Chart
This unit obtains 2 DMX channels and can match to use with any international standard DMX512
controller.
CH1: STROBE (speed) CH2: DIMMER (0-100%)
