R2P-IC3A/4A
I/C BASEPLATE
Subject to change without notice • REV 2020.11.29
This product must be installed in accordance with the
applicable code by a person familiar with the construction
and operation of the product and the hazards involved. Read
all of these instructions before installing.
WARNING:
Rated for insulated ceilings only (IC rated)
Mark approximate fixture
location in ceiling
Caution: Careful attention
should be made to cut
within the hole diameter
for the best fit
Pull electrical wire through
newly cutout hole
8
To secure housing, install
sheet metal screws as
required to lock hanger bars
in place. Screws by others
4
Slide hanging bars onto
housing base plate
1
Line up bottom edge of
hanging bars with bottom of
wood joist and hammer in
tabs. Nail or screw hanging
bars into place
2
3a — Position trim hole to
desired location by sliding
housing
3b — Use centering holes on
either side of housing base
plate to line up a row of
fixtures
3
Cut open using baseplate
hole as your guide
6
Remove the Knock outs and
make appropriate electrical
connections.
See Dimming Instruction
Diagram.
7
5