IMPORTANT NOTES
1.
Before fitting the stainless steel hardware apply a small amount of anti-seize to the thread of the
35mm mounting bolts.
2.
Mounting points vary in design and load capacity, ensure the light is within manufacturers recom-
mended weight specifications before fitment.
3.
Failure to correctly mount light may cause damage to light and vehicle
LIGHTFORCE AUSTRALIA
VENOM & GENESIS LED USER INSTRUCTIONS
V1.0 / DECEMBER 16
MOUNTING BRACKET
1.
Remove nyloc nut and M10 washer from
M10 x 35mm bolt attached to the bottom of
mounting bracket
2.
Locate the bracket in a suitable position
using the M10 x 35mm bolt. It is
recommended that the base area of the
mounting bracket is totally supported
3.
Align light to preferred driving position
4.
Fit the washer and M10 nyloc then tighten
using a 17mm socket & ratchet to specified
torque (35Nm)- do not use rattle guns.
5.
Tighten 2 x M10 x 35 side bolts to
recommended torque (35Nm).
VENOM & GENESIS LED INSTALLATION INSTRUCTIONS
