Inspecting Female Connectors
To inspect female connectors (in
bulkheads and patch panels) plug
the 4-pin jack on your probe into
the socket on the side of ViewConn
– the flat side of the jack will face
the rear – and set the camera
switch, above the red on/off button
to EXT.
With the correct tip installed for
the connector type, place the tip of
the probe into the adapter and use
the focus knob on the probe to
focus the image. If you are unable
to focus, you may not have the
probe tip fully inserted. Make sure
it seats fully, and refocus.
Remember, when using the probe, focus with the probe knob.