Actual product characteristics may vary
www.lightculture.com.au
CUTTING
INSTALLATION
–
Ensure the supply cord is not subject to mechanical stress
–
IP67 Snap connectors:
Keep at least 10mm distance between the end of the profile and the end mounting piece
–
Press the flex light into mounted aluminium channel in one direction. Bend angle should be less than 15°.
NEON Y | INSTALLATION & MOUNTING
INSTALLATION DIRECTION
<15°
<10MM
<10MM
PROFILE
END CAP
POWER FEED
5/8
–
Neon can only be cut where cutting
marks are present. Look for the “Dotted
Line” or “Scissor Mark”.
–
Cutting outside of the specified mark
will damage the light and cause a failed
segment.
–
A cut section must have the
appropriate IP67 Snap connector
power feed or end cap accessory to
maintain IP ratings.
See Neon IP67
Snap Connection Installation at end
of Installation Guide information on
fitting these.
–
Where installation is known to require
cuts on-site the purpose-built cutting
tool should be purchased with your
order from your distributor.
IP
6
8 INJECTION MOULDING:
DO NOT
cut off the cable wire between the
waterproof metal ferrule and connector.
CUTTING MARK
R
L
24
V
+
R
L
24
V
+
WATERPROOF METAL FERRULE
–
Do not let Neon bow in centre (from installing from both ends)