Light4Me COMPACT MOVING HEAD 7x8W, User Manual, Page: 7 / 17

3-
Sound Activated Mode
The unit responds to sounds picked up by the unit in microphone to create a light show . Each
sound picked up makes changes to color shown and position of the effects. This mode enables the
unit to act a Master to other Slave units Choosing Sound Activated
To select, use the “MODE/ESC" button and choose “NStS”. When the “ENTER" button is pressed
the LED Display changes to “SrUn” and the unit enters Sound Activated Mode.
4-
Slave Mode
Up-to 32 units can be daisy chained together with one single unit acting as Master and all other linked
units as Slaves. Slave units will all run in synch with the master unit without the need for an additional
controller. Connections can be made using standard DMX control cables with Master unit running in
Auto Run or Sound Activated Modes an placed at the start of the chain
Choosing Slave Mode
To select, use the “MODE/ESC” button and choose “SLAu”. When the “ENTER" button is pressed the
LED display changes to “Son” and the unit will be slaved to control signals coming from a Master unit
5-
Service Modes
After major configuration changes it may be necessary to reboot or reset the unit.
Resetting the Unit
To select, use the “MODE/ESC” button and choose TEST"(restore). Press “ENTER" to confirm. The
unit powers itself down and then on again for a few seconds. During this time the LED display will
scroll TEST” from left to right, after which normal operat ion recommences. Restoring factory defaults
To select, use the “MODE/ESC” button and choose “LoAD”(load). Press “ENTER” to confirm. The LED
display will change to “d001” to confirm a factory reset has been completed Powering the unit
initially
During the warm up the unit will auto test itself for a few seconds. During this time the led display will
scroll TEST" from left to right .The unit then commences operation normally
6-
DMX Modes
The unit supports 9 and 14 channel DMX Sub-modes trim a standard desk. When a suitable DMX
connection is made, the "decimal point” in “d.001” will flash.
Setting DMX Addresses
Use the “MODE/ESC" button to display “d001”, “UP” and “DOWN” buttons allows individual DMX
addresses to be set from “d001" to “d512”
Choosing between DMX Sub-modes
The LED display shows the chosen control mode when the “MODE” button is pressed. Use “UP” and
“DOWN” buttons to choose the appropriated DMX control Mode
LED Display DMX Sub-mode
9CH 9Channel
14CH 14channel
Color Options