1.2
Unpacking instructions
Once receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts
are presented, and have been received in a good condition. Notify the shipper immediately and
retain packing material for inspection if any parts appear damaged from shipping or the carton
itself shows, sign of mishandling. Save the carton and all packing materials. In the event that a
fixture must be returned to the factory, it is important that the fixture be returned in the original
factory box and packing.
1.3
AC Power
To determine the power requirements for a particular fixture, see the label affixed to the back plate
of the fixture or refer to the fixtures specifications chart. A fixture listed current rating is its average
current draw under normal conditions. All fixtures must be directly powered off a switched circuit
and cannot be run off a rheostat (variable resistor) or dimmer circuit, even if the rheostat or
dimmer source voltage matches the fixtures requirement. Check the fixture or device carefully to
make sure that if a voltage selection switch exists that it sets to the correct line voltage you will
use.
Warning! Verify that the voltage select switch on your unit matches the line voltage applied.
Damage to your fixture may result if the line voltage applied does not match the voltage indicated
on the voltage selector switch. All fixtures must be connected to circuits with a suitable Earth
ground.
1.4
Safety Instructions
Please read these instructions cy, it includes important information about the installation, usage
and maintenance of this product.
Be sure that the local power outlet match that of the required voltage for your unit. Do not attempt
to operate this unit if the power cord has been frayed or broken. Do not attempt to remove or
break off the ground prong from the electrical cord. This prong is used to reduce the risk of
electrical shock and fire in case of an internal short.
Disconnect from main power before making any type of connection.
Do not remove the cover under any conditions. There are no user serviceable parts inside.
Never operate this unit when its cover is removed.
Never plug this unit in to a dimmer pack.
Always be sure to mount this unit in an area that will allow proper ventilation.
Allow about 6 inch (15cm) between this device and a wall.
Do not attempt to operate this unit, if it becomes damaged.
During long periods of non-use, disconnect the unit's main power.
Always mount this unit in safe and stable matter.
Power-supply cords should be routed so that they are not likely to be walked on or pinched by
items placed upon or against them, paying particular attention to the point they exit from the unit.
1.
Preface
1.1 Packing list
Product name
quantity
Flat Par Light
1 pcs
Power -line
1 base
User Manual
1pcs