Light
and stick the LED to an
Adhesive Square.
With the cable facing the
inside of the roof, stick the Bit Light to the following position underneath the
front of the roof tip.
Bring the roof over the house and reconnect it over the bedroom via the brown
clip plate, then bring the other end of the White Bit Light cable up over the
brown angled clip piece before securely reconnecting the right roof panel by
pushing it down. Connect the White Bit Light to an available port on the 6-Port
Expansion Board below. The Pink Bit Light should be positioned perfectly in the
middle underneath the front of the roof tip as shown below.
Summary of Contents for LEGO Gingerbread House 10267 Lighting Kit
