Turn the set around, then disconnect the fire section from the front of the
firepalce by the black 2
×
4 plate.
16.)
Take one of the fire sections and disconnect and discard the trans orange
round plate from the front. Take a
White 15cm Bit Light
and ensuring the cable
is facing the right side, place it over the black stud underneath where the trans
orange stud was. Secure the Bit Light in place by connecting a provided LEGO
Trans Orange Round Plate 1
×
1
over the top.
Summary of Contents for LEGO Gingerbread House 10267 Lighting Kit
