Important Note: If using the smartphone App to control the lights and motor, the lights will
only turn on when the train is in “accelerate or reverse mode )+ or -)”. The lights will
automatically turn off when the motor is turned off or when “STOP” on the controller/app is
pressed.
Note: If you experience any issues with the lights not working and suspect an issue with a
component, please try a different port on the expansion board to verify where the fault lies (with
the light or expansion board). To correct any issues with expansion board ports, please view the
section addressing expansion board issues on our
online troubleshooting guide.
7.)
From the back of the train, lift up the roof, then take a
White 15cm Bit Light
, and with the
cable facing down, place it in the following position underneath the roof. Secure the Bit Light in
place by connecting a provided
Trans Clear Plate w Rounded Bottom 2×2
over the top.
