3
Installing Urban onto your bike
Your Light & Motion Urban light head comes with a universal bar/helmet
mount. To install on your handlebar, determine the best place on the bar
to mount as it relates to your specific brake & shifter layout. Ideally,
Urban should be mounted as close to the stem as possible. After
determining the proper location, wrap the strap under and around the
handlebar, pulling it up and over the mounting post in front of the light (fig 15).
Note: Tighten the strap only enough to prevent slipping around the
bar. Pulling the strap too tight can eventually cause a premature failure.
To remove, simply release the strap from the locking post.
Installation of Urban
Fig 15: Urban on bar
(strap over post).
Figure 17: Mount
tight on helmet.
Installing Urban onto You
The Helmet mount is designed to be mounted on any standard,
vented bicycle helmet. Position the base of the helmet mount on
top of the helmet, in the middle and slightly forward of center.
Slide the hook and loop strap down through the proper vent, back
up through the opposing vent, and finally through the slot in the
base of the mount. Pull the strap tight and slide it back down the
vent and affix it to the “loop” side of the strap inside the helmet
(fig 17). Now install Urban just like you would on a handlebar (see
instructions “Installing Urban onto your bike”).