7
Mounting Light Head QuickConnect
1)
Remove the attached arm mount using a 1/8 allen wrench.
2)
Align QuickConnect details with slots on light head.
3)
Tighten Socket Cap Screw to secure mount to light head.
Mounting QuickConnect Base
1)
Remove arm base using 5/32 allen wrench.
2)
Attach QuickConnect and tighten Socket Cap Screw.
Attaching Light Arm to Light and Housing
1)
Align arm mounts into slots on light or housing base.
2)
Push slightly and rotate clockwise. Arm should click into place.
Removing Light Arm from Light Head and Housing
(Refer Fig. 6)
1)
Pull lock ring away from light or housing and rotate counter-clockwise.
Assembly with Universal Mounts
Mounting Arm to Housing
Press arm FIRMLY into base until arm snaps into place (Refer fig. 7).
Mounting Arm to Light Heads
Align top of arm with arm light head base and press FIRMLY together. Arm
should snap into position. (Refer fig. 8).
Removing Arm from Light Heads
To remove light head from arm, “break” the arm at the upper most joint.
Applying pressure on the Light Arm and not the Light Head (Refer fig. 9). Do
not apply pressure to the Light Head Base (Refer fig. 10). Doing so may cause
the Base to break from the Light Head damaging the light.
(Fig. 7)
(Fig. 8)
8
Connecting Battery to Light Head
1)
Plug in the cable connectors on pod.
2)
Tighten the locking sleeves by rotating clockwise until tight.
1)
Plug in the cable connectors on the Light Head
2)
Tighten the locking sleeves by rotating clockwise until tight.
Light Operation
Before you turn on the lights, verify that the mode selector (flat position
of black ring around red power button) is set to the P setting.
Operation with Mako housing
If your Mako is equipped with a Monitor Back, the SunRay-S Pro lights can
also be operated from the Smart Grip controls.
Operation from Smart Grips
1)
Activate initial power up by pressing the Pod Power Button. (Refer Fig 11).
After initial power up lights may be controlled using LIGHT button on the
Smart Grip controls.
2)
Turn off lights by pressing the LIGHT button.
Operation from Battery Pods
1)
Turn on light by pressing the Power Button on the rear cap (Refer Fig 11).
2)
Turn off light by pressing the Power Button on the rear cap.
(Fig. 9)
(Fig. 10)
(Fig. 11)
Power Button
Light Head
Base
