Welcome
Congratulations on your purchase of the Sunray 2000 LED light system.
Please inspect the packaging of your product to verify that there was no damage
during shipping.
Periodically refer to http://www.uwimaging.com for instruction revisions.
Caution - Caution - Caution - Caution
To increase your enjoyment and the life span of your equipment please take
an extra minute to review common errors which will result in equipment
damage or destruction.
•
Always remove batteries from battery pods before storage
or travel. Failure to do so may inadvertently power-on the
lighting system and possibly cause heat damage.
• Check the operation of all your equipment several weeks prior to your trip.
If maintenance or repair is necessary, then time is available for both shipping
and repair scheduling.
• If a battery pod is flooded, immediately remove the battery. POD: rinse
with fresh water (good) or rubbing alcohol (better). Shake vigorously, towel
dry, and leave the pod where it can drain excess moisture. BATTERY: Dry
the battery off, blow any water out of the connectors, and then shake the
battery to remove remaining moisture.
If there is water inside the
battery do not attempt to use it again.
If the battery seems damp
inside, allow it to dry for at least 24 hours, away from flammable items.
Then, on land, charge the battery and test your lights before attempting
another dive.
Caution:
The Sunray 2000 LED Lighting System is designed for use underwater.
Prolonged operation in air may cause the outer surfaces of the light to become
hot. Light & Motion recommends that you limit the operation of the Sunray light
out of the water to less than two minutes.
3
Warning • Warning • Warning • Warning
Warning • Warning • Warning • Warning