Operation With Other Brands of Video Housing
1. Turn on light by pressing the red button on the rear cap (Refer Fig 7).
2. Press the red button again to change the light output level.
3. Turn off light by holding the red button down for three seconds.
Post-Dive Cleaning
1. After each dive, you should dunk the lights and pods in fresh water.
2. Press the red button to flush out any salt water.
3. After you are geared down and completely dried off, simply towel dry the
lights in a safe dry place.
Do not leave your lights in the rinse bucket with other
equipment. Video lights have been damaged by jostling
against other products.
Storage
After diving remove your batteries and charge them. Leaving your batteries
discharged will significantly reduce the life of the battery. The lighting system
requires no special storing instructions. Store as you would any other
valuable piece of electronic equipment.
Other Maintenance
•
CLEAN THE CONNECTORS!!! — Pay special attention to the condition of
the connectors at the end of the cables. Equally important is the female
receptacle in the battery pod. These metal connectors should “shine like a
new penny”.
•
Apply a light film of O-ring grease to cables and connectors to prevent
premature degradation.
~
9