8. Partial Open/Height Setting
a)
Press and hold
SET
Button until “1” appears on the display, next
press the
UP
button until “8” appears on the display to enter this
function setting then release the button.
b)
Press the
SET
button again. The unit is now in partial-open/height
adjustment mode. You will see a figure “0” with a flashing dot on the
display.
c)
Press
UP / Down
button once to select if you want to open the
partial open function or set the partial open height. (0~9).
Press
UP
button to increase , or
DOWN
button to decrease.
Figure “0”
: Close the partial open function.
Figure “1~9”
: Set the partial open position of the whole travel.
One tenth to Nine tenths of the whole travel etc...
d)
Press
SET
button to confirm the settings and it will return to
standby status automatically and display “ll”.
NOTES:
1.
The partial open/height is set on “0” as default.
2.
If you use the partial open/height function, the buttons’ recognition function will be disabled.
3.
Other details please refer to the Instruction manual of the remote carefully.
4.
If you enabled the partial open function then disabled this function later, please note that only the
coded button you have programmed can control the operator.
SET
UP
C
ODE
DOWN
SET
UP
C
ODE
DOWN
increase
decrease
SET
UP
C
ODE
DOWN
SET
UP
C
ODE
DOWN
17
