IMPORTANT: PLACE THE LIFETONE HL™ NEXT TO YOUR BED, WITH THE SPEAKER FACING YOUR PILLOW.
Plug in the bed shaker
Install 4 D-Cell
alkaline batteries
STEP 1
- POWERING THE HLAC151™
STEP 2
- SETUP WITH YOUR SMOKE DETECTOR
5.
You may plug in the bed shaker now or at any time after setup.
1.
Remove the battery door from the back of your HLAC151™.
2.
Insert four D-cell alkaline batteries as shown in the illustration at right,
matching the polarity signs (+ and –) in the open compartment. You
should do this before plugging your HLAC151 into a wall outlet.
3.
Replace the battery door securely. A flashing “TEST” on the screen
tells you the batteries are installed correctly.
4.
Plug the Lifetone HLAC151 into an electrical outlet near your bedside.
Don’t use an outlet that is controlled by a wall switch.
NOTE:
The HLAC151 operates on AC power. The batteries are only for backup during electrical outages.
6.
The word “TEST” continues to flash on the screen. Go to STEP 2.
Smoke alarm has been detected.
Successful test. You may
now set the clock.
4. Go to the most distant smoke alarm you want detected. If your alarms are interconnected, use the
nearest one instead. Press and hold the test button on the smoke alarm until the Lifetone HL™
alarm sounds, indicating a successful setup test. Between two and six T3 cycles (groups of
3 beeps) of the smoke alarm will be required. You’ll need to hold the smoke-alarm button
down for 10 to 30 seconds.
6. When the test is sucessful, the Lifetone HL™ alarm sounds and “ F I R E ” flashes on the screen.
IMPORTANT WARNING: If you have First Alert alarms with voice, see section
IV., OPERATING
INSTRUCTIONS,
in the HLAC151 User’s Manual.
5. If the test is not successful, try again using a nearer smoke alarm. You may try as
many times as you like. Your HLAC151 will continue with this test until it is successful.
7. When the setup test has finished, the “12 hr” option for the time display appears on the screen
and your HLAC151 says, “
Now, set the clock.
” Go to STEP 3.
1. The word “TEST” is flashing on the screen and your HLAC151
™
says, “
Press the red
button to begin.
” Press and release the red TEST/SILENCE button on the back.
T3 ALARM
SIGNAL
Press the TEST/SILENCE
button to start the test.
Doc# LTQSG151E131227
TEST/SILENCE
WARNING! DO NOT COVER
AC POWER
HLAC151
4 D-Cell Alkaline
Batteries
Bed Shaker
HLAC151 User’s Manual
Thank you for purchasing the Lifetone HL Bedside Fire Alarm and Clock. These items are included:
™
KEEP THIS QUICK-START GUIDE IN A SAFE PLACE
Remove the
battery door
SETUP
VIDEO
QUICK START GUIDE
LIFETONE HL
™
BEDSIDE FIRE ALARM AND CLOCK
MODEL HLAC151 WITH EASY SETUP
2. “TEST” stops flashing and your HLAC151 says, “
Please wait.
”
3. After about 30 seconds, “TEST” starts flashing again and your HLAC151 says, “
At the tone, test your
smoke alarm.
”
This
means it’s time to press the test button on your smoke alarm.
If the setup test has not been successful after several tries, the smoke alarm may not be
issuing a T3 signal. See the section titled “
TESTING THE LIFETONE HL
™
” in the User’s Manual.
TEST/SILENCE
BED SHAKER
BED SHAKER
Read and follow all the printed intructions below. The voice prompts supplement these instructions.
