19
Operating
Instructions
GRILL BURNER LIGHTING
Warning: Do not lean over grill when lighting. Turn
off LPG
supply at cylinder when appliance is not in
use.
Main Burner Lighting Illustration:
1. Check that the control knobs are in the OFF
position.
2. Open valve at tank fully by turning
counterclockwise.
3. The door must always be in the OPEN position
for lighting;
4. Push the Electronic Ignition down 3 to 4 seconds
while turning the control knob to the HIGH position.
The burner should ignite.
If ignition does not take place within 5 seconds,
immediately turn the control knob to the OFF position. Wait
5 minutes and repeat step 4 above or refer to match lighting
instructions in manual.
If by chance the electronic igniter does not light the burner,
the burner may be lit with a match attached to the match
extender, located on the inside of the cabinet door.
Remove the base grate and pizza stone. Keep your face as
far away from the burner surface as possible and pass the
match extender to the ports of the main burner tubes.
Position the match near the burner ports and push and turn
the control knob counterclockwise to the
“HIGH” position. After the burner has lit, turn the knob
to the "LP LOW" position and carefully place the flame tamers and grates back in position.
Then turn the control knob to the desired setting.
Keep any electrical supply cords and the fuel supply
away from any heated surfaces.
Main Burner Control Knob
