13
SP960
b. Exercise distance can be set, MAX 99 KM/MI, each press add 0.1, countdown to zero, the
DIST will flash and beep for 5 seconds.
4. CALORIE
/RPM: Window D displays
a. Counts the cumulative calories consumed from exercise start to the end, and also the
current RPM (or cadence).
b. The calorie value can be set, MAX 999, each press add 1, countdown to zero, the CAL will
flash and beep for 5 seconds.
5. PULSE/AVG. PULSE/ MAX PULSE: Window E displays
a. Shows your current heart rate, average, and max heart rate during exercise, pulse range:
40
～
220BPM
6. AUTO OFF
a. Without any exercise signal or operation over 4 minutes, the computer will turn off
automatically and memorize the current data.
INSTALLATION:
1.
Take off the computer back’s battery cover, put 2pcs 1.5V AAA battery inside correctly.
2. Fix the computer on the front place of exercise bike by screw.
3. Install the magnet and speed sensor on the related place of the bike. Make sure the distance less
than 10mm between the magnet and sensor.
4.
Connect the speed signal cable plug and the computer back’s signal plug. If with pulse, connect the
hand pulse cable plug and the
computer back’s pulse signal plug.
5. Ride the bike, and if the speed value changes, means the installation is correct. Or else check the
installation of magnet and sensor, and also the plug connections between sensor and computer.
OPERATION:
1. RESET
In any displays, hold MODE button for 2 seconds to reset all the data.
2. SET THE TARGET PARAMETERS
When stop exercise (icon
not display), press MODE to choose the window to be set or reset, the
corresponding window displays SET, meanw
hile, the window’s digit flash, press RESET to clear the
value, and press SET to set the flashing window’s value. Hold the button to quick increase.
Set the value as: TIME
→
DIST
→
CAL.
3. CHECK THE EXERCISE DATA
a. In non-set mode, press SET or during exercise, icon displays, press MODE to separately check
the SPEED / AVG. SPEED /MAX SPEED, CALORIES/RPM, PULSE/AVG. PULSE/ MAX
PULSE.
b. When icon
displays, means the computer is scan the display. It will scan display the value in
corresponding window every 6 seconds.
4. PULSE RECOVERY
Wear the transmitter belt properly, or hold the hand pulse place, the computer will display your
current heart rate.
When the pulse window has the display, stop exercise, press RECOVERY to enter the function of
pulse recovery. The display will show 1 minute countdown as well as your pulse rate, test your pulse
until it counts down to zero. Then it will pop up your pulse recovery level from F1 to F6, that is, from
the fastest recovery to the slowest. The fastest recovery F1 shows the best, F6 means the slowest.
Press RECOVERY again to exit the pulse recovery function.
Summary of Contents for SP-960
Page 5: ...5 SP960...
Page 6: ...6 SP960 3 EXPLODED DIAGRAM...
