6
| IMPORTANT OPERATING INSTRUCTIONS
III. IMPORTANT OPERATING
INSTRUCTIONS
•
Understand that changes in speed and incline do not occur immediately. Set your desired speed on
the computer console and release the adjustment key. The computer will obey the command
gradually.
•
Use caution while participating in other activities while walking on your treadmill, such as watching
television, reading, etc. These distractions may cause you to lose balance or stray from walking in the
centre of the belt; which may result in serious injury.
•
This unit starts with at a very low speed. It is recommended to stand on the side rails and only step
on the treadmill as it is moving on a slow speed. This will prolong the life of your motor and run the
belt smoothly.
•
This unit starts with at a very low speed. It is recommended to stand on the side rails and only step
on the treadmill as it is moving on a slow speed. This will prolong the life of your motor and run
the belt smoothly.
•
Always hold on to handrail while making control changes.
•
A safety key is provided with this machine. Remove the safety key will stop the walking belt
immediately; the treadmill will shut off automatically. Inserting the safety key will reset the display.
•
Do not use excessive pressure on console control keys. They are precision set to function properly
with little finger pressure.
•
Replace any defective components immediately. The machine must be kept out of use until repaired.
•
Belt wear-in period: all treadmills make a certain type of thumping noise due to the belt riding over
the rollers, especially new treadmills. This noise will diminish over time, although may not completely
go away. The belt will stretch over time, causing it to ride smoother over the rollers.
•
Set up your machine for storage when the machine is not in use to ensure maximum longevity of
electrical components via the following steps:
1. Ensure incline (if applicable) is reset to zero.
2. Remove the safety key to prevent unauthorised use.
3. Turn off the machine via the red on/off switch located at the back of the motor. If your
machine does not have a switch, turn off the machine at the wall power outlet.
Summary of Contents for LFTM-VIPER-M4
Page 28: ...28 EXPLODED DIAGRAM X EXPLODED DIAGRAM...
Page 29: ...29 EXPLODED DIAGRAM...
Page 36: ...WWW LIFESPANFITNESS COM AU...