ELECTRICAL INSTALLATION
1. Switch on the internal rechargeable battery.
Note:
If external power fails, the internal backup batteries can
supply operational power to the Base Unit for 15 to 26 hours,
depending on the battery type in the Base Unit.
Battery Switch
Battery 1
Battery 2 (optional)
Turn over the Base Unit, open the battery compartment
and push the battery switch to the ON (UP) position.
The LS-30 Base Unit can accommodate 2 rechargeable battery packs.
Battery pack 1 is 9.6V/800mA(built-in) and Battery pack 2 (optional) is 9.6V/600mA, providing 15-26
hours back up time.
2. Plug in the power adaptor.
3. Key in the Installer password.
(The default Installer password is “1234”.)
(Refer to the
Passwords Block in page 8.
)
4. Enter the
Installer Mode
. (Refer to
(4) Installer Mode
).
5. Program the basic settings
a) Telephone numbers (Refer to
(4-2) Set Telephone – (4-2-1) Set Telephone Number
) or GSM numbers, if
equipped with GSM module. (Refer to (4-7) Set GSM )
b) Record voice message
(Refer to
(4-3) Set Sound-Record Voice
)
c) Enroll all the wireless devices by registering their ID codes in the Base Unit.
(Refer to
(4-4) Set Device-Enroll Device
)
6. Set other functions if necessary.
7. Connect the telephone line, GSM module (if using GSM module for communication, refer to the
APPENDIX A-6
), Data Communication Module or Ethernet adaptor (if remote access is needed,
refer to the
APPENDIX A-3
).
Note:
For GSM module, Data Communication Module and Ethernet adaptor, please refer to their user guides.
8. Install the Wireless Siren and register the Base Unit’s ID code into the Wireless Siren.*
* This is only needed for the system equipped with optional Wireless Siren.
(Refer to
(4-5) Set Siren-Siren/Relay Test
and the instructions of the Wireless Siren)
9. Enter into
Master Mode
and adjust the clock. (Refer to
(3) Master Mode – Set Clock
)
10. Test other functions, if any have been set.
For details, please read the description on the following pages carefully.
All the above settings also can be done through the proprietary GUI program “HyperSecureLink”.
Please refer to the “HyperSecureLink” User Guide.
5
Summary of Contents for LS-30
Page 3: ...INTRODUCTION INSTALLATION 1...
Page 9: ...USER OPERATION 7...
Page 21: ...INSTALLER CMS SETTINGS 19...