2.2 Installation Instructions
1 .
Drill openings according to the
template, and then place the lock
body into door jamb.
5 .
Insert a square strip into the lock body from inside the door
to outside (the longer side of the square strip facing the
front plate and springs inserted both sides of the strip).
6 .
Place the cable of the front panel
through the opening and seal the panel.
7 .
Separate the back panel and its
cover case (silicone pad and
stainless steel cover).Place cables
from front panel through the matched
openings, then fix the cylinder crews.
8 .
Connect cables from front panel to
the right sockets on back panel.
Remove the cover of the battery
compartment, adjust it and tighten fix
4 screws on the panel.
2 . Connect the TDG anti-theft
spindles with the lock body.
(Skip this step if it is a wooden door)
4 . Connect the threaded rod according
to the thickness of your door. Install the
handle in line with the direction of
openings. Use a cross tip screwdriver to
tighten the oriental screw and fasten the
square hole towards handle.
3. Fix 4 screws on the lock body.
The oriental screw is on loose in the lever handle when it is shipped.
Please pull it out from the right handle direction and tighten it accord-
ing to your opening direction.
ATTENTION
11
12
Outside
Indoor
Cable
Square Shaft
Spring
Lock body
