12
Sonic M1
User Manual Lifepro
SoarFX Collection
13
Please read the operating instructions before using the
Sonic M1
.
Keep this manual for reference.
CHARGING THE BATTERY
• Fully charge your
Sonic M1
before using it for the first time.
• Always power off the Sonic M1 before charging.
• To charge: turn the device off, then plug the charging adapter into the
port on the bottom of the unit. Plug the charging adapter into a wall
outlet.
• The Battery Icon at the base of the handle illuminates when charging.
• Full charge is indicated when the digital Power Display shows “100%.”
• Your
Sonic M1
typically takes 3–5 hours to charge.
• The digital Power Display at the base of the handle indicates the current
battery level from 1–100%.
• When the battery level is less than 30%, the Battery Icon will flash.
• When the battery level is less than 10%, the Battery Icon and the digital
Power Display will both flash. When this occurs, power off the unit and
fully charge it before using again.
• Average run-time is 2–3 hours per charge at higher speeds and 5–6 hours
per charge at lower speeds.
USING YOUR
SONIC M1
1. Slide the
Power switch
on the bottom of the handle to the ON position
to power on the
Sonic M1
. The lights on the control panel will turn on.
2. Tap (short-press) the
Selection button
on the control panel to enter
standard speed mode. Vibration will begin at speed level 1, indicated
by the blue LED on the far left. To change vibration speed in standard
mode:
a. Tap (short-press) the
Selection button
once to change the vibration
speed to level 2. Tap the button a second time for speed level 3. Tap
a third time for level 4.
b. Tap the
Selection button
again to change the vibration speed to
level 5, indicated by the red LED on the far left. Tap the button
again for speed level 6, and so on, up to speed level 8. Tap a ninth
time for Intelligent Intensity (AI) standard mode.
c. The 4 Speed Indicator LEDs will show the speed level selected.
Speeds 1–4 are indicated by blue lights. Speeds 5–8 are indicated
by red lights. When Intelligent Intensity is selected, the Intelligent
Intensity LED will be lit.
3. If desired, press and hold the
Selection button
on the control panel for
2 seconds to enter automatic mode. Vibration will begin automatically
in Ramp-Up Mode. To choose a different vibration pattern in automatic
mode:
a. Tap (short-press) the
Selection button
once to change the mode to
Wave Mode. Tap the button a second time for Cool-Down Mode. Tap
a third time to go back to Ramp-Up Mode.
b. The 3 Automatic Mode Indicator LEDs will show the automatic mode
selected.
4. With your desired vibration speed or automatic mode selected, float the
head of the massage attachment along a muscle group. Apply pressure
as needed.
5. Slide the
Power switch
on the bottom of the handle to the OFF position
to power off the unit. Always power off the unit after each use.
6. The unit will automatically power off after 10 minutes of use.
REMOVING AND REPLACING A MASSAGE ATTACHMENT
1. Slide the
Power switch
on the bottom of the handle to the OFF position
to power off the unit.
2. Grab the inserted attachment and firmly pull out to remove it.
3. Insert the stem of a new attachment into the nozzle of the unit.
4. Press the attachment in firmly to secure it.
