10
BioHeal User Manual Lifepro
Please read the operating instructions before using the BioHeal Red Light Therapy
Panel. Keep this manual for reference.
USING THE CONTROL PANEL
1. Display Window:
Shows the set working
time.
2. Mode Indicator LEDs (2):
LEDs indicate the
current selected mode.
3. Time (T) Button:
Press to set the time
duration from 1–30 minutes, in 1-minute
increments. The default time is 10 minutes.
4. Mode (R/NIR) Button:
Press to toggle
through the three modes: red + near-
infrared mode (660+850nm), red mode
(660nm), and near-infrared mode (850nm).
5. On/Pulse/Off Button:
Press the button
once to turn on the LED lights, press a
second time to turn on the 10 Hz pulsed
light feature, press a third time to turn off
the LED lights.
MODE OPTIONS
RED LIGHT, 660NM WAVELENGTH (MODE 2)
• Improves skin health
• Boosts blood circulation
• Stimulates collagen and elastin production
NEAR-INFRARED LIGHT, 850NM WAVELENGTH (MODE 3)
• Decreases inflammation
• Relieves muscle and joint pain
• Repairs deep tissues such as muscles, joints, and organs
RED LIGHT + NEAR-INFRARED LIGHT, 660+850NM (MODE 1)
• Combines the benefits of red light and near-infrared light.
NOTE:
Near-infrared light is not visible to the naked eye.
USING THE BIOHEAL RED LIGHT THERAPY PANEL
1. Place the protective eyeglasses over your eyes.
2. Flip the red power switch on the back of the panel to the ON position.
3. Press the
On/Pulse/Off button
on the control panel to turn on the LED
lights and begin treatment using the default treatment, Mode 1, red light +
near-infrared light (660+850nm). The display window will show the default
working time of 10 minutes, "10:00".
4. Press the
Mode (R/NIR) button
to change the mode, if desired. Press the
button once to change to Mode 2, red light (660nm); press a second time to
select Mode 3, near-infrared light (850nm); and press a third time to return
to Mode 1. You may change the mode at any time.
5. Press the
Time (T) button
to adjust the working time, if desired. The default
working time is 10 minutes. Choose from 1–30 minutes, in one-minute
increments. The set working time appears in the display window and may be
adjusted at any time.
6. Press the
On/Pulse/Off button
a second time to turn on the 10 Hz pulsed
light feature, if desired. The LEDs on the panel will pulse, or flash, on and
off rapidly in a cycle.
7. Press the
On/Pulse/Off button
a third time to stop the treatment session
at any time. The BioHeal will automatically shut down when the set working
time is complete. Press the On/Off/Pulse button again if you wish to
continue using the device.
8. Always press the
On/Pulse/Off button
to turn off the LED lights, flip the
power switch on the back of the light panel to the OFF position, and unplug
the device after each use.
Wellness Recovery Collection
11
PULSED LIGHT THERAPY
By default, the BioHeal uses continuous waves of red light. When the 10 Hz
pulsed light feature is turned on, the panel emits rapid pulses of red and/
or near-infrared light (depending on the mode selected). 10 Hz is the pulse
frequency and refers to the pause between one "on" time to the next (the
light pulses on and off 10 times per second).
Emerging research shows that the short pause between light pulses
encourages cells to regenerate more efficiently, meaning pulsed light has a
greater effect on cell regeneration and recovery.
5
3
4
2
1
