13
Assembly STEP 5
Remove the three Washers
(#10)
and three Nuts
(#11)
that
are pre-assembled on the Seat
(#9)
. Then, attach the Seat
(#9)
to the Seat Tube (enhanced)
(5E)
and secure it with three
Washers
(#10)
and three Nuts
(#11)
that were previously
removed.
Attach Bellows
(#12A)
to the Seat Tube (enhanced)
(#5E)
as
shown in illustration below.
Insert the Seat Tube (enhanced)
(#5E)
into the opening of the
post that is protruding from the Main Frame
(#1B)
a minimum
of 4 inches to engage the lowest hole. Please ensure that the
hole on the Seat Tube (enhanced)
(#5E)
is facing the same
side as the hole located on the Main Frame
(#1B)
and
insert the Knob
(#17)
through the Main Frame
(#1B)
post and
through the hole on the Seat Tube (enhanced)
(#5E)
. Please
refer to the illustration below.
Always ensure that the Knob
(#17)
is securely tightened
and engaged through the hole on the Main Frame
(#1B)
and
thehole setting most comfortable to you on the
Seat Tube (enhanced)
(#5E)
for your safety.
Hardware Required
E
1B
#10 Washer (M8)
[3 pieces]
#11 Nylon Nut (M8)
[3 pieces]
#17 Knob (M12)
[1 piece]
QM894
Page
