11
Assembly STEP 4A
Remove the two Special Washers
(#29)
, two D Shape
Washers
(#14)
, and two Bolts
(#13)
that are pre-assembled on the
Handlebar Axle
(#16)
Set them aside close by as they will
be used in this step.
(#15),
two Washers
(#72)
, two Spring Washers
Insert the Handlebar Axle
(#16)
through the Main Frame
(#1B)
, making sure the Handlebar Axle
(#16)
is centered.
If you encounter too much friction, try using WD40 or
Vaseline as a lubricant.
Next, on the right side, slide one Special Washer
(#29)
on
Handlebar Axle
(#16)
followed by Right Handlebar
(#4RA)
and secure with one D Shape Washer
(#15)
*** [please see
close-up diagram/note below], one Washer
(#72)
, one Spring
,
Washer
(#14)
and one Bolt
(#13)
. Repeat this process on
the left side using Left Handlebar
(#4LA)
.
Linkage
(#6R)
. With the help of an assistant, on the
right side as shown in drawing below, insert one Bolt
(#18)
through the Right Handlebar
(#4RA)
followed by one Washer
(#19)
and then the Bushing
(#34)
of Right Linkage
(#6R)
.
Secure these together from the other “inner” side of Right
Linkage
(#6R)
using one other Washer
(#19)
and one Nylon
Nut
(#20)
. Repeat this process on the left
side with the Left Handlebar
(#4LA)
.
Hardware Required
4LA
4RA
1B
[***When assembling D Shape Washer
(#15)
, please ensure
of Handlebar Axle
(#16)
as marked in close-up diagram below.
]
#13 Bolt (M10x18 mm)
[2 pieces]
#18 Bolt (M8x43 mm)
[2 pieces]
#20 Nylon Nut (M8)
[2 pieces]
#29 Special Washer
[2 pieces]
#14 Spring Washer (M10)
[2 pieces]
#15 D Shape Washer (M10)
[2 pieces]
#19 Washer (M8)
[4 pieces]
#72 Washer (M10)
[2 pieces]
QM894
Page
