ASSEMBLY INSTRUCTION:
STEP 1: Attach the rear strut. Remove
the indicated end cap from the rear
of the main frame(part A). Discard it.
Slide rear strut (part B) into the rear
of the main frame (part A) , screw in
4 Phillips screws, securing rear strut
to main frame.
STEP 3: Attach the handlebars.Remove the screw, nuts and washers from the rotation
rod (part N). Slide handlebar rotation rod through the linkage tube at the top of main
frame. The rod may need a lithe lubricant to easy slide through the bushings at either
end of the linkage tube. Center the rod and rotate it until the set hole in (the rod aligns
with the hole in the center of the linkage tube. Screw the fixing screw into the aligned
hole and secure it. Remove the parts and bike from the carton and identify them using
the expanded illustration. Attach the left handle (D), the left handle is marked with an
"L". Put the handlebar pivot housing on the left side of the rotation rod. Slide the
rotation rod's thread stem through pivot housing bushings. Place a washer on stem and
screw on nut. Place the plastic end cap you can find it in the screw pack onto nut after
final tightening. Attach the right handle (E) in the same manner. Slide the foam grips (M)
on to the handlebars. A small amount of liquid soap will ease installation.
STEP 2: Mount the front strut. Place
front strut (part C) into saddle
bracket at the front of the frame. The
square holes must be placed in down
position.Align the holes in the front
strut with the holes in the bracket
and put 2 carriage bolts through the
holes. Place 2 washers on bolts and
screw on 2 dome nuts and tighten
5
6
Summary of Contents for Fit Lite Airbike
Page 8: ...WEIGHT LOSS 13 14 ...
