7
ASSEMBLY INSTRUCTIONS
Step 1
Connect the Sensor Wire I (51) from the Base Stabilizer (26) to the Sensor Wire II (52)
from the Handlebar Support (29). Then install the Handlebar Support (29) to the Base
Stabilizer (26) by inserting the Handlebar Support (29) into the Base Stabilizer (26), using
four M8 Spring Washers (40) and four M8x16 Bolts (43). Tighten bolts with the Allen
Wrench with Phillips Screwdriver Provided.
IMPORTANT:
While sliding the handlebar support into the base stabilizer, make sure the
wires are installed inside the handlebar support and pay attention not to pinch the wires.
Hardware:
4 Spring Washers (M8)
4 Bolts (M8x16)
Allen Wrench with Phillips Screwdriver 5mm
Tool:
52
51
29
29
43
40
43
40
