7
• Slide two ACCORDION SLEEVES (33) and two PILLOW BLOCKS (26) over the PIVOT ARM (4) as shown in FIGURE 4
STEP 4
FIGURE 4
•
SECURELY
assemble the PIVOT ARM (4) to the ARM SUPPORT (2) using four previously inserted 3/8 X 3” BUTTON HEAD
CAP SCREWS (17), four RH WASHERS (23), four 3/8” SAE WASHERS (21), four 3/8” LOW HEIGHT LOCK NUTS (19) and
four RH CAPS (44) as shown in FIGURE 5.
STEP 5
:
FIGURE 5
33
26
4
• Attach two 1-1/4” RUBBER BUMPER (31) to the ARM SUPPORT (2) where the PIVOT ARM (4) shaft contacts tube in both
directions.
TIGHTEN!
SET SCREWS
3/8 X 3” 17
2
19
44
23
4
31
•
IMPORTANT!
When PIVOT ARM (4) is centered and level in the PILLOW BLOCKS (26), tighten the PILLOW BLOCK set
screws.
31
21
43
17 3/8 X 3”
BUTTON HEAD
• Assemble four 3/8 X 3” BUTTON HEAD CAP SCREWS (17) and four STARLOCK WASHERS (43) to the the PILLOW
BLOCKS (26) as shown in FIGURE 4.
