5
4.
Place the
ferrule
insert
(5) in
to the
hole of rear bracket(3)
slide the operator arm
(6) on
to the
bracket(3),
aligning the
hole with ferrule insert
.
Position the bolt
(7)
and push through the operator arm and rear bracket hole. Secure with the self locking nut(8)
5.
Fix operator (6) on front bracket (3) with screws closing strongly.
6.
Open and close manually the gate several times, and check gate movement is regular, and operator movement is parallele to the gate
movement.
7.
Check ferrule support perfectly slides on operator’s screw nut, and that with gate opened and closed, at least 5 mm remain between ferrule
screw nut and opening & closing
stops
.
8.
If necessary, use different hole on rear bracket, repeating operations shown on point c) & d).
9.
Define accurately opening and closing positions of gate leaves, adjusting
the stop
positions in the following way:
§
bring gate in closing position on mechanical stop,
§
loose
n
closing
stop
(1) with
allen
key and
move it up until it touches the drive pin bracket
(5); then re
-tighten
the screws
firmly
and
insert the
headless
locking screw(6). Tighten the headless
screw(6).
§
bring gate leaf in
to
the
required
open position
§
loose
n the
opening
stop
(2) with
an allen
key and
move it up until it touches the drive pin bracket
(5); then re
-tighten
the screws
firmly
and
insert
the headless screws(7).
Tighten the headless screw.
10.
R
e
-
lock the operator
with the manual release key by turning 360 degrees clockwise
.
12.
Re-fit the worm screw cover, then the motor cover.
OP20014
OP20015
OP20013
1
5
6
2
5
7
3
7
6
8
5
ENGLISH
2MANUALE (INGLESE) Life.indd 5
30-10-2008 15:17:13
