E-Gel
®
iBase
™
with the E-Gel
®
Imager Light Base
The E-Gel
®
Imager Blue-Light Base
and E-Gel
®
Imager UV Light Base
can be used to provide transillumi-
nation for the E-Gel
®
iBase
™
.
For best results, affix the E-Gel
®
Imager Light Diffuser to the bottom
of the E-Gel
®
iBase
™
when using this
configuration.
Installing
the E-Gel
®
iBase
™
with
the E-Gel
®
Imager
Light Base
Page 2
Installing
the E-Gel
®
iBase
™
with
the E-Gel
®
Imager
Adaptor Base
DC Connector
Cable
1. Place the E-Gel
®
iBase
™
directly onto the transilluminator surface of
the E-Gel
®
Imager Light Base.
2. Connect the DC Connector Cable between the E-Gel
®
iBase
™
and the
E-Gel
®
Imager Adaptor Base.
3. Connect the E-Gel
®
iBase
™
power supply cable to the 48 V power
port at the rear of the E-Gel
®
Imager Light Base.
4. The E-Gel
®
iBase
™
Device is now ready for use with the E-Gel
®
Imager system.
E-Gel
®
Imager
Adaptor Base
E-Gel
®
iBase
™
Device
The E-Gel
®
Safe Imager
™
can be
used with the E-Gel
®
Imager
Adaptor Base to provide
transillumination for imaging with
the E-Gel
®
iBase
™
Device.
Note
: Make sure to press the ON
button of the E-Gel
®
Safe Imager
™
.
for 2 seconds to extend the dura-
tion of transillumination.
Important
: There are two types of
plug on the E-Gel
®
Safe Imager
™
.
Choose the appropriate
installation method for the E-Gel
®
iBase
™
/E-Gel
®
Safe
Imager
™
based
on whether your E-Gel
®
Safe
Imager
™
has Plug A, or Plug B.
Plug A
Plug B
E-Gel ImagerBase.indd 2
8/10/2011 4:15:23 PM
All manuals and user guides at all-guides.com
