7
Control Panel
Remote Control
FIREPLACE OPERATION
Plug your Infrared fireplace heater power cord into a 120V, 15amp or 20amp three-bladed receptacle.
To Turn the Fireplace On
: Press the Power button
on the control panel or on the remote
control.
Default Set Temperature
: The default set
temperature every time the heater is powered on is
typically 72°, this cannot be changed.
Ambient Temperature:
To view the ambient room
temperature, press and hold the Temp up
button for a few seconds, the room temperature will
display for a short period of time, then return to the
desired set temperature.
To Set Desired Temperature:
Press the UP
or DOWN
button on the
control panel or on the remote control. When the
desired set temperature is reached by the heater’s
internal thermostat, the heater will stop heating
automatically, but the fan will continue to run for
approximately 5 minutes (3 minutes when powered
off) so that unit’s chamber can cool. When the
ambient temperature drops below the set desired
temperature, the heater will cycle on again.
To Set Heat Level:
Press the H/L button
on
the control panel or remote control to switch
between High and Low heat. The corresponding High (H) or Low (L) light will switch on. In
the High mode, the fan will not change speeds. Rather, the heating elements will allow for
higher heat output. The High level uses 1500 watts, while Low heat level uses approximately
1000 watts.
Celsius and Fahrenheit:
The heater displays temperature in Fahrenheit as the default, but
has the capability to display it in Celsius as well.
To change between °Celsius and °Fahrenheit:
Press
To Set Flame Brightness
: Use the Dimmer button
on the control panel or remote
control. The flame brightness control button is used to increase or decrease the brightness of
the flame and ember
. Press once, the brightness will start and keep changing. Press
again to set the desired level.
