20
LIFE | M7 X/M7 X UC NG
LifeIonizers.com/support
Function Options
aMPS aND LITeRS PeR MINUTe (LPM)
NOTe: the unit must be dispensing water before pressing the buttons.
• Press and hold
“FILTER 1”
&
“FILTER 2”
simultaneously for 5 seconds in
order to enable the display of the Amps & LPM reading indicator light.
• Two numbers will then appear on the indicator.
• The top number is the amps number followed by the digit A.
• The bottom number is the Liters per Minute (LPM) followed by the
digit L.
• Once the LPM is displayed, you can make the necessary adjustment
to the water flow in order to adjust the LPM to the unit. Adjust the
LPM by
slowing down water flow to ionizer from the source water:
- Under Counter -
Cold Water Connect
-
Counter Top
-
Faucet Adapter
key NOTe: The slower the flow, the stronger the alkaline or acidic
water is produced. We recommend that you set the machine
between a flow of 1.5-2.5LPM.
• For strong 11+pH alkaline or 2.5 pH acid water, we recommend
that the flow rate be set at 1.1-1.5 LPM. Do not set below 1.0 LPM
because it will error out and display E1.
NOTe: Your pH will be determined by your water source. If you’re
on well water, your water is soft, or your TDS is too low, then you
might need a remeneralizing cartridge or a pre-filter to add alkaline
minerals so your unit can ionize properly.
NOTe:
FLOW RaTe MUST Be SeT TO GeT PROPeR PH LeVeLS.
Set flow rate no higher than 2.5 liters per minute. Anything higher could cause internal damage.
Amps & LPM (liters per minute) indicators
