PHASE 2
PROGRAMMING THE TRAVEL
PHASE 1
PROGRAMMING THE CONTROL UNIT
DEFINING THE STOP PLATES
Ensure that the automation’s opening and closure stop plates have been fixed.
1
2
F
F
O
230V
OFF
1
3
ON
ON
230V
2
O
F
F
230V
N.B. In case just one motor is utilised, choose from Menu Options 2 “Activate single motor” and connect on terminals 20-21-22
b) Press
for 5 seconds, the 5 LEDs will light and
then start flashing.
c) Press
and the gate starts rolling, if it opens
press again
to invert the movment.
The first activated limit switch has to be the one of the
closing system.
Finished the two flash programming
green LED will be lit and a steady light led the two
reds.
If the result was not satisfactory, you can
perform a programming manual to determine the
lags. See Section 3.3.4
a) Position the leaf gates at 45°.
STOP PLATES -
Ensure that the open and close stop plates are set to the correct position
SINGLE MOTOR -
In the case of a single gate installation connect the motor into terminals 20-21-22
before programming enter the options 2 menu and select single motor activated (led 4
on)
AUTOMATIC PROGRAMING
POWERING UP
- With the power off, hold the start button down ,reinstate the power supply and release the
button the red led’s will fl ash
Secs
PHASE 2
PROGRAMMING THE TRAVEL
a) Press start
or 5 seconds, the 5 LEDs will light and
then start flashing.
b) Press
and the gate starts rolling,
if it open press again o
the movment.
The first activated limit switch has to be the one of the
closing system.
The automation will perform, in sequence, a closure
(1)
,
an opening
(2)
, a closure
(3)
.
Once programming is complete, the two green LEDs will
flash and the red led
( )
will light.
Should the result obtained not be satisfactory, repeat the
whole process.
S
E
LOS
C
S
N
E
OP
S
E
S
O
L
C
1
2
3
Ensure gate is in central position (half open) and
manual release is locked before proceeding
Energy Saving
In order to save energy, we have introduced the function
Energy Saving. 10 minutes after the end of programmation of the control board, the LED
of the keyboard go out and it is no more possible to use the control board. To get the control
board working again, switch it off and on.
PROGRAMMING THE TRAVEL
a) Press start
or 5 seconds, the 5 LEDs will light and
then start flashing.
b) Press
and the gate starts rolling,
if it open press again o
the movment.
The first activated limit switch has to be the one of the
closing system.
The automation will perform, in sequence, a closure
(1)
,
an opening
(2)
, a closure
(3)
.
Once programming is complete, the two green LEDs will
flash and the red led
( )
will light.
Should the result obtained not be satisfactory, repeat the
whole process.
N.3 Not for RG1R DL UNI version.
