8
Step 2
Connect the Sensor Wire II (23) from the Right Handlebar Support (25R) to the Sensor
Wire III (24) from the Computer Support Bracket (56). Then install the Computer Support
Bracket (56) to the Right and Left Handlebar Supports (25R, 25L) by inserting the
Computer Support Bracket (56) into the Right and Left Handlebar Supports (25R, 25L),
using two M8 Spring Washers (67) and two M8x16mm Bolts (81).
NOTE:
Do not fully tighten hardware in step 2 until step 4 is completed.
IMPORTANT:
While sliding the computer support bracket into the right handlebar support,
make sure the wires are installed inside the computer support bracket and pay attention
not to pinch the wires.
Hardware:
2 Spring Washers (M8)
2 Bolts (M8x16mm)
Allen Wrench with Phillips Screwdriver
Tool:
24
56
81
67
25R
25L
23
