7
ASSEMBLY INSTRUCTIONS
Step 1
Connect the Sensor Wire I (22) from the Base Frame (2) to the Sensor Wire II (23) from
the Right Handlebar Support (25R). Then install the Right and Left Handlebar Supports
(25R, 25L) to the Base Frame (2) by inserting the Right and Left Handlebar Supports
(25R, 25L) into the Base Frame (2), using six M8 Spring Washers (67) and six M8x16mm
Bolts (81).
NOTE:
Do not fully tighten hardware in step 1 until step 4 is completed.
IMPORTANT:
While sliding the right handlebar support into the base frame, make sure the
wires are installed inside the handlebar support and pay attention not to pinch the wires.
Hardware:
6 Spring Washers (M8)
6 Bolts (M8x16mm)
Allen Wrench with Phillips Screwdriver
Tool:
2
81
67
67
81
67
25R
25L
81
23
22
