Smith Machine PL06 Unpacking & Assembly Instructions
2
UNPACKING
Follow the steps below when unpacking the components of the crate. Keep in mind that
the sides of the PL06 are large and heavy. This machine requires three people to uncrate
.
1. Remove the shipping wrapper.
NOTE:
DO NOT REMOVE THE FOUR HOLLOW TUBE BUMPERS (SHOWN IN
UNPACKING FIGURE 1) UNTIL YOU HAVE COMPLETED ASSEMBLY OF THE PL06.
THESE BUMPERS ARE FOUND ABOVE AND BELOW THE BEARINGS ON THE BAR
CARRIAGES. REMOVAL OF BUMPERS PRIOR TO INSTALLATION OF THE BAR MAY
RESULT IN SEVERE DAMAGE TO THE LINEAR BEARINGS.
Unpacking Figure 1. Leave the hollow tube bumpers until the bar has been installed.
2. Remove the loose parts.
Remove all parts other than the sides of the PL06 in the
order shown below:
A. Remove the packaging on the bar carriages as shown in Unpacking Figure 1.
The parts in the box are shown in the back of these instructions in the section
HARDWARE
.
B. Starting at the bottom and working upward, remove the packing from the bar. It is
strapped to the plate horns as shown in Unpacking Figure 2. Remove the bar and
set it aside.
