Don’t run the engine in an enclosed room and poor-ventilated place, since
exhaust emission from the engine contain toxic carbon monoxide (CO),
which may make people lose consciousness, even lead to death.
2. PARTS DESCRIPTION
(Fig.1)
3. PRE-OPERATION PREPARATION
3.1 Connecting water inlet pipe
Use commercially available hose, hose joint and clamp. The water inlet hose must be of continuous
structure and be non-folded. The length of the hose should be as the same as or not more than that
required. The effect of suction is greater the shorter distance from the water surface.
Suction time varies with the length of the water inlet hose in direct ratio. The filter matching with the
water pump should be mounted to the end of the water inlet hose with a hose clamp.
(Fig.2)
CAUTION
:
Before pumping, install the filter securely to the end of the water inlet hose. The
filter flits any impurity, which may produce passage jam to damage impellers.
Be sure to install the hose joint and clamp well so as to prevent from air leaks
and pumping performance drop; loose water inlet hose will decrease the water
pump performance and self-suction ability.
© by WilTec Wildanger Technik GmbH
Seite 4
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
