L I F A N P O W E R U S A
Page 26
Operation of Generator
•
Keep the generator away from other electric cables or wires such as commercial power supply lines.
•
The DC receptacle (in the
Battery Charge
section of the control panel) can be used while the AC power is in use. If
you use both at the same time, be sure not to exceed the total power for AC and DC.
•
Most appliance motors require more than their rated wattage for start-up.
•
It is normal for the run time indicator to have 1-2 hours on the meter from the factory for testing and
quality assurance inspections.
•
This generator uses a system ground which connects the ground terminals in the AC receptacles
on the control panel to the unit frame. The AC neutral wire is not connected to the system ground. If you check the
receptacles on this generator with a receptacle tester, the ground circuit condition will appear different than it would
for a receptacle in your home.
1.
Unplug all electrical loads from the generator.
2.
Make sure the generator is in a level position.
PULL START (RECOIL) MODELS: Your ESI 2500iER-EFI-CA & ESI 3100iER-EFI-CA is
recoil and Electric Start
3.
Place the ignition switch in the “ON” (l) position using the provided key.
4.
Grasp starter handle and pull slowly until resistance is felt. Then pull the cord rapidly with a
full arm stroke. Allow the rope to return slowly. Do NOT allow the rope to snap back against
housing.
