Installing Optional Items
9
4.0
I
NSTALLING
O
PTIONAL
I
TEMS
4.1
RPC BDM—Basic Display Module
The RPC BDM provides local display of electrical status for all connected Liebert MPH systems. Dis-
play information is accessed via a navigation switch on the RPC BDM. The RPC BDM is cable-con-
nected to the Liebert RPC allowing the user to locate the display to suit the local reading
requirements. A 2-meter cable and general mounting provisions are provided. A single display can be
used for up to four Liebert MPH connected in a Rack PDU Array
™
.
Figure 8
RPC BDM
4.2
Install an Optional RPC BDM in the Rack
The RPC BDM (Basic Display Module) can be mounted in the rack with either the included hardware
or with a cable tie through the slot on the back of the module (see
Figure 9
). Either method permits
moving the RPC BDM to a different place in the same rack or to another rack.
4.2.1
Mounting Hardware
• Spring nut M5: 1
• Spacer sleeve: 1
• Special MPH screw: 1
• Cable clip: 1
Tools Required
• Flat-blade screwdriver
4.2.2
RPC BDM Installation on Knurr Miracel Frame
1. Determine the mounting location in the rack.
2. Insert a spring nut into a T-slot on the frame member where the RPC BDM will be installed (refer
to
Figure 3
).
3. Insert the Liebert MPH screw into the spacer sleeve.
4. Insert the Liebert MPH screw into the spring nut and tighten securely with the screwdriver.
5. Hang the RPC BDM on the Liebert screw with the hooded mounting slot on the back of the RPC
BDM (see
Figure 9
).
6. Connect the RPC BDM to the Liebert RPC with an Ethernet cable.
Be certain to connect the cable to the correct port on the Liebert RPC (see
Figure 10
).
