Liebert MONITORING OpenComms, User Manual

Page: 38 / 56

Firmware Updates
32
Once the last file is downloaded,
the screen at right will appear.
Repeat Steps 2 through 4 to
change the baud rate back to 9600 bps as
show in the illustration below right.
After the communication settings are
adjusted, hit the Enter key on your key-
board. The screen at right will appear.
You can also cycle power on the Open-
Comms NIC card. This action will also
initiate communications and provide
information on current revision status.
Once the “Initializing Network…” line
appears, hit the Enter key on your key-
board.
Select
X and the card will reboot.
To ensure that the latest firmware is
downloaded to the OpenComms NIC
card, cycle power by removing and
restoring the power connection at TB3.
The information below will appear.