LIBHOF B-35H, User Manual

Page: 12 / 38

23 22
English English
8. PROBLEM SOLVING
Fault Possible cause Suggested remedy
Device does not function,
LED light does not glow.
No voltage was
detected in the DC
power supply. In most vehicles the ignition
must be turned on before power
supplied to the DC power outlet.
The cooling device
plug fuse is defective. Replace the device plug fuse by
a new one.
The device does not cool
(plug is inserted , «ON»
LED is lit)
Defective compressor
This can only be repaired by an
authorized repair center.
The device does not cool
(plug is inserted, display
screen shows Error
Code»E1»).
Please also refer to chapter
«5.6 The explanation for
the running code shown in
the display screen»
Low voltage
protection battery
monitor is set too
high.
Select a lower level for battery
monitor
Battery voltage is too
low. Test the battery and charge it if
needed
When operating the
device from DC outlet.
(the ignition is on, but the
device is not work, the
LED light is not on either)
The DC outlet is dirty,
this result in a poor
electric contact.
If the plug of your device
becomes very warm in the DC
outlet, either the DC outlet must
be cleaned or the plug has not
been assembled correctly.
9. DISPOSAL
Place the packaging material in the appropriate recycling waste bins wherever possible.
If you wish to finally dispose your device, ask your local recycling center or specialist
dealer for details about how to do this in according with the application disposal
regulations.
10. TECHNICAL DATA
NOTE
The coolant circuit contains R134a.
Contains fluorinated greenhouse gases.
Hermetically sealed equipment.