7
the wheels with the adjustable bolts. Rear brake adjustment is shown below. See assembly instructions for front brake
adjustments.
General Operating Instructions
BEFORE YOU RIDE
1. Charge your battery until the green indicator light on the charger comes on.
2. Check the air pressure of the tires. Make sure they are at the recommended
psi embossed on the sidewall of the tire.
3. Check the front and back brakes, and the condition of the front and back
wheels, handlebar, and saddle. Make sure they are tight and fastened. Make
sure all quick releases are locked and secure and that all parts are in good
working order. Inspect your bike completely.
4. If it was removed, install the charged battery in the battery seat of bike and
lock it.
5. Raise the kick stand.
6. Sit on the bike and turn the bike on. The power lights/meter should show
your battery capacity.
7. Pedaling or using the throttle on the right hand will begin to accelerate the
bike.
ATTENTION: After the power is on, if the rider twists the throttle the
bike will lurch forward! Do not turn the power on until you are ready to
go.
Some of our 744 models have a circuit breaker under the seat.
This is
turned OFF for shipment and safety. Before riding your bike, you must
turn the circuit breaker to ON.
The brakes will automatically cut the power to the motor even if the
throttle is engaged. This is for safety and protection for the motor.
ATTENTION:
When riding down hills, do not turn off the power,
otherwise the controller and motor will be easily damaged which is NOT
covered under warranty.
.
Locking Battery Box
Adjusting Upper Adjuster Nut
Lock steering by turning
wheel to the left, then turn
the key all the way counter
clockwise and remove the
key.
en
en
Summary of Contents for Town & Country II
Page 15: ...15...
