6
Please fix the four screws tightly with tool.
4. INSTALLING THE MIRRORS AND WINDSHIELD (Optional)
The windshield is an option that is installed when installing the rear view mirrors.
1. Install the channel brackets underneath the nut that holds each of the rear view mirrors. The channel is the receptor
for the L-bolt (shown in picture #2).
NOTE: The nut on the bottom of the bracket must be inserted up inside of
the brake handle housing to ensure that the mirror will thread into the nut.
2. On the L-bolt, screw one nut on the short end of the L-bracket and slide two plastic holders over the long end of the
L-bolt.
3. Take the two chrome-colored flat brackets that have two bolts coming out of the sides and place the rubber washer
over the bolts, then place the bracket from the front side of windshield through the holes in the windshield. Slide the
small rubber washers over the end of the bolts to provide cushion for the bracket against the windshield.
1. Fasten channel bracket.
2. Assemble L-bracket as shown. 3. Assemble windshield brackets.
4. Fasten windshield to L-bracket. 5. Windshield with bracket fastened.
If you only have the mirrors and no windshield, then screw the right and left mirrors into the threaded holes on the handle
bars. Thread them in as far as possible by hand, and then tighten the nut to secure in place. Adjust to fit your preference.
5. BRAKE ADJUSTMENT
Please check front and rear brakes before you use this scooter. The adjustable bolt will allow the brake handle to tighten in order
to stop you quickly. These usually need to be adjusted when they are delivered. Both front and rear brakes are adjusted down at
.
Position metal plates inside of rear
box as shown here.
Summary of Contents for Town & Country II
Page 15: ...15...
