6 | EN
Copyright © Liberty Pumps, Inc. 2021 All rights reserved.
5672000J
(9/16 socket) on the discharge flange. This will compress the
rubber ring and seal the unit.
9.
Open the valve so that the handle/latch encompasses the
discharge elbow. If problems exist with opening the valve,
adjustments can be made to the height of the discharge
elbow by loosening the three screws on the discharge flange
and raising or lowering the height as needed. Verify screws
are re-tightened after adjustment.
10.
The control box is designed to be mounted higher in the pit’s
access chamber and above a potential flood level should a
power outage occur. Ten feet of cable is provided to the
control box to accommodate various pit heights. Mount the
control box as high as possible to the existing vent pipe using
the supplied brackets and hose clamps. The brackets must
first be screwed onto the control panel, then install the hose
clamps through the slotted openings on the bracket.
11.
The 6-pin electrical connector (either round or square) will
mate up with the existing E/One plug in the pit. No splicing is
required. Simply connect the plugs together and ensure they
are fully engaged.
Note:
The manual override switch will remain operational in
the original equipment E/One panel.
12.
An auxiliary or second nameplate is provided and should be
fastened to the existing control panel to properly identify the
new pump.
Operation
Starting System
1.
With all electrical and mechanical connections complete and
secure, turn on power to pump and control panel, if
applicable.
2.
Verify operation of the pump, floats, and alarm circuits.
3.
Run several cycles of water through the system to verify
correct control operation for the installation.
Note:
The alarm float acts as a redundant ON float, activating the
alarm and pump in the event of a main float switch failure.
Maintenance and Troubleshooting
Refer to supplied Omnivore Installation manual.
Warranty
Liberty Pumps Wholesale Products Limited Warranty
Liberty Pumps, Inc. warrants that Liberty Pumps wholesale
products are free from all factory defects in material and
workmanship for a period of three (3) years from the date of
purchase (excluding* batteries and “Commercial Series” models).
The date of purchase shall be determined by a dated sales receipt
noting the model and serial number of the pump. The dated sales
receipt must accompany the returned pump if the date of return is
more than three years from the date of manufacture noted on the
pump nameplate.
The manufacturer's sole obligation under this Warranty shall be
limited to the repair or replacement of any parts found by the
manufacturer to be defective, provided the part or assembly is
returned freight prepaid to the manufacturer or its authorized
service center, and provided that none of the following
warranty-voiding characteristics are evident:
The manufacturer shall not be liable under this Warranty if the
product has not been properly installed, operated, or maintained
per manufacturer instructions; if it has been disassembled,
modified, abused, or tampered with; if the electrical cord has been
cut, damaged, or spliced; if the pump discharge has been reduced
in size; if the pump has been used in water temperatures above
the advertised rating; if the pump has been used in water
containing sand, lime, cement, gravel, or other abrasives; if the
product has been used to pump chemicals, grease, or
hydrocarbons; if a non-submersible motor has been subjected to
moisture; or if the label bearing the model and serial number has
been removed.
Liberty Pumps, Inc. shall not be liable for any loss, damage, or
expenses resulting from installation or use of its products, or for
indirect, incidental, and consequential damages, including costs of
removal, reinstallation or transportation.
There is no other express warranty. All implied warranties,
including those of merchantability and fitness for a particular
purpose, are limited to three years from the date of purchase.
This Warranty contains the exclusive remedy of the purchaser,
and, where permitted, liability for consequential or incidental
damages under any and all warranties are excluded.
*Liberty Pumps, Inc. warrants StormCell
®
batteries for 1 year from
date of purchase, and warrants that pumps of its Commercial
Series are free from all factory defects in material and
workmanship for a period of 18 months from the date of
installation or 24 months from the date of manufacture,
whichever occurs first, and provided that such products are used
in compliance with their intended applications as set forth in the
Clamps
Discharge
Cam locks
