DL-ILFO-H2 Owners Manual
4
Installation Instructions
Connect the DL-ILFO-H2 transmitter and receivers USB port to the supplied power supplies and connect to
a local power source. The DL-ILFO-H2 transmitter can be powered by 5V from pin #18 of the HDMI interface
however the receiver must receive a constant power supply @ 5V/1A, some TV’s and projectors may be able
to supply this power via a USB A port but if the power supplied by the TV is not stable or sufficient enough, it
is recommended to use the provided power supplies on each extender device. Always the check the available
USB power on a TV to be sure the receiver will receive the correct amount of voltage and amperage if using this
method.
NOTE:
Digitalinx recommends using
both
USB power supplies connected to both transmitter and receiver for a
stable power connection and supply.
When power is supplied the power LED will turn ON.
Connect Power
Connect Fiber Cables to Extenders
Connect a duplex LC OM3 optical fiber cable between the transmitter and the receiver, note that each fiber
channel should be connected as (A) to (A) and (B) to (B) respectively.
The maximum length for the OM3 fiber cable is 200m / 660’. This extender will not work with single mode fiber
cable for longer distances.
NOTE:
Digitalinx does not recommend or support cable interrupts or pass-throughs in the fiber cable such as
keystone plates or patch panels, this may cause undesired interruptions in system performance.
